Additional Images

Dryflow Filter - 2.75" Mouth


5 min

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to

Was: $69.00
Sale: $62.10
Save: 10%
Save: $6.90


PERRIN Dry media, Dryflow Filter

Universal application 2.75" I.D. inlet filter.

This is a direct replacement for the 2008-2014 WRX and 2008-2017 STI Cold Air Intake. It will also work on any intake system which accepts a 2.75" filter.

Filter Tech

Dryflow filters provide the same level of protection as an oiled filter, but require less maintenance, are less of a mess, and have no risk of over-oiling. The rigid screen inside and around the filter media helps in preventing damage from debris and are ideal for dusty and rough driving conditions.

Cleaning Instructions

  • REMOVE FILTER: Remove filter from the intake pipe and lightly tap off all loose dirt and debris.

  • APPLY CLEANER: Liberally spray Dryflow cleaner onto both sides of the filter, with the majority of it applied to the dirty side. Allow to soak in for 10 minutes. Do not allow it to dry on the air filter.

  • RINSE FILTER: Rinse off the filter element with cool or warm (not hot) water from the clean side out in order to flush the dirt out of the filter. It may be necessary to use your fingers on the hose, to apply light water pressure. Repeat steps 2 and 3, until the water flowing through the media is completely clear of any dirt and debris.

  • DRY AND RE-INSTALL FILTER: After rinsing, gently shake off excessive water and allow to dry naturally or carefully use compressed air to help speed the drying cycle. Re-install the filter onto the intake system, airbox or custom assembly once it is dry or just slightly damp. Follow all original installation instructions.


Warranty Details

This product features a 5 year warranty Read Full Warranty

Tech Department




Overall Width 6"
Overall Height 11"
Inside Diameter 2.75"
Foam Type Dry media, dryflow

Compatibility Detail

Direct replacement for 2008-2014 WRX/STI Cold Air Intake (Part # PSP-INT-322). Works on any intake system which accepts a 2.75" filter


2.75" Intake System Yes
Replacement for PERRIN FMIC Setup No, click here

In The Box

In The Box

(1) Cone Filter with 2.75" Mouth
Mounting Clamp


Shipping Information

  • Item Requires Shipping
  • 2.0 lbs.
  • W8.0000” x H8.0000” x L14.0000”
  • This item ships in its own box.